Prevent heat stress in feedlot cattle
Summer heat waves pose a serious danger to cattle in feedlots.
“Not only is there elevated risk of death loss, but there is also the reduction in performance and efficiency to consider,” said Warren Rusche, SDSU Extension Cow/Calf Field Specialist.
To reduce heat stress on cattle in feedlots, Rusche encourages cattle producers to develop a plan before hot and humid conditions hit so they are in a better position to deal with the conditions and minimize the impact on their cattle.
“The amount of stress cattle are under is affected by both the air temperature and the relative humidity,” Rusche said, referencing Figure 1. “The combination of high temperatures plus high relative humidity is particularly dangerous, especially when there is little to no night-time cooling.”
He explained that solar radiation and air movement aren’t accounted for in this index, but they are a major component in determining how high temperatures affect cattle.
Below, Rusche outlines factors cattle producers should consider when working to reduce heat stress.
“Water access is vitally important to maintain the well-being of cattle during hot weather. Water consumption can be 2.5 times greater at 90 degrees Fahrenheit compared to 70 degrees Fahrenheit,” Rusche said.
The water system needs to have enough capacity to satisfy cattle demand at all times. There should be at least 3 linear inches of trough access per head.
Extra tanks may be required to ensure enough access and holding capacity. Maintaining and keeping tanks clean will help make sure that water intake is not limited.
Rusche added that heat stress can also be reduced by using sprinklers to cool both the cattle and ground.
“It is important not to create a fine mist that will only increase humidity and make the situation worse,” he said.
Introduce sprinkling to cattle prior to extreme heat and before the cattle are under significant heat stress; waiting until the cattle are overheated is too late. An additional supply of emergency water may need to be acquired so that the system can meet both sprinkler and drinking water demand.
Shade reduces the radiant heat load on the cattle as well as the ground temperature. “Providing a layer of light colored bedding will also reduce the temperature of the soil surface in an unshaded pen,” Rusche said.
Removing barriers to air movement, such as temporary windbreaks or tall vegetation close to the pens will help increase airflow and provide some relief.
Consider temperature before working cattle
“When possible, avoid working cattle during heat waves. If it is absolutely necessary to move or work cattle during hot weather, plan on being done before 9 to 10 a.m.” Rusche said.
He explained that the core temperature of cattle peaks about two hours after the peak air temperature and it takes roughly 6 hours for cattle to dissipate their heat load. “So even if it cools down at night the carryover effects from earlier in the day could be enough to cause problems if cattle were worked,” Rusche said.
Some other management steps to reduce heat stress related losses include:
* Pay particular attention to cattle that are at higher risk for heat stress. These include heavy cattle, those with dark hides, and those with past health problems.
* Controlling flies will help keep cattle from bunching in a group, allowing for more airflow to each animal.
* Feed 70 percent or more of the daily ration in the late afternoon or evening. Delaying feeding times has been shown to reduce the animal’s peak body temperature.
* One method to determine whether or not to reduce morning feed deliveries is to monitor early morning respiration rates. If cattle are still breathing faster at 6 or 7 AM that’s an indication that the heat load didn’t dissipate overnight and offering less feed and sprinkling more often would be warranted.
* Feeding MGA to heifers has been associated with less death loss due to heat stress, presumable because of less riding activity.